สินค้าทั้งหมด

A robust and easy to install separator divides the recycled aggregates into sand and gravel.

ดูรายละเอียดเพิ่มเติม

A ComTec machine equipped with an external row of buckets. This compact solution lifts the waste from washing out concrete pumps or the batching plant into the ComTec without placing the machine below ground level. The external buckets are mounted on an extension of the main shaft of the machine.

ดูรายละเอียดเพิ่มเติม

The advantage of a dosing buffer derives from the possibility to discharge several trucks at higher speed.

The dosing buffer collects the residual material and continuously feeds it into the connected recycling machine.

The produced washing quality as well as the separation cut of the fines contained in the greywater is assured as they are independent of the evacuation speed of the trucks. Due to the higher discharge speed of the trucks the total time for the discharge and wash process of the trucks is significantly reduced.

ดูรายละเอียดเพิ่มเติม

- Purification of residual/wash water with fine particles
- Purification of coloured water
- Simple handling of the filter cake
- Little space required, high filtration performance of the system
- Low operating and maintenance costs

ดูรายละเอียดเพิ่มเติม

- Recycling capacity of 4, 10, 20 and 30 m³/h
- Dosing buffer and a special extension allow for fast discharge into the machine
- Large capacity wash drum (0.5-3.5 m³) guarantees best performance
- Compact design. No foundation mobile option available.
- Light aluminium cover supported by gas pressure springs
- Heated option available
- Hot-dip galvanised for longevity

ดูรายละเอียดเพิ่มเติม

- Recycling capacity of 4, 8, 12 and 18 m³/h
- Compact design. No foundation mobile option available.
- Heated option available
- Hot-dip galvanised for longevity

ดูรายละเอียดเพิ่มเติม

BEVEL LENGTH (L): max 22 mm

BEVEL ANGLE: 15° - 60° (*)0°-60°

ดูรายละเอียดเพิ่มเติม

PORTABLE CHAMFER MILLING MACHINE
K-HFM/KaKi 2014-1-8-E

45°, 30°, 60° chamfers

The most economic way to mill 45°, 30°, 60° chamfers. The chamfer milling machine is used whenever predefined chamfers must be machined and is employed for the preparation of weld seams. This handy and powerful machine can also be utilised to produce visible edges. Furthermore, the machine can also be used to deburr sharp corners safely. Equipped with a radial mechanical stop, which is used as guide roller, the tool can also be used to machine inside contours and pipes.

Application range
· Sheet metal, pipes, flanges, inside contours, bores, etc.
· Steel, aluminium, stainless steel, castings, non-ferrous, metals, and plastics

ดูรายละเอียดเพิ่มเติม

Self-aligned welding rotator including one power and one idle, after load on the work-piece, the roll will auto suit the workpiece, no need to adjust the center distance. The transmission mechanism: motor---multi-step speed adjust----roll, can adopt frequency speed adjust

ดูรายละเอียดเพิ่มเติม