สินค้าทั้งหมด

Machine a V bevel in a plate up to 200 mm thick for butt welding or edge conditioning with a chamfer angle of 15° to 60° at a automatic feed speed of up to 1.4 meters/minute.  The rigid frame incorporates steel where required and aluminum casting where permissible to optimize strength and ergonomics. The motorized feeding process is achieved over hardened work plates with sliding rollers, all driven by two 90 shore polyurethane wheels. 

Motor Power
230/400 Volt, 3 Phase
4kw (4000W), 50/60 Hz

Bevel Length
max 55 mm

Bevel Angle
15° – 60°

Plate Thickness
8 mm – 60 mm (*) 8 mm – 100 mm / 8 mm – 200 mm

Pipe
Ø min 3000 mm

Feeding Speed
0 -1.4 mt/min

Machine a reverse downside chamfer with an angle of 0° to 60°, or a square edge condition a plate up to 100 mm thick at an automatic feed speed of up to 1.4 meters/minute.

Motor Power
230/400 Volt, 3 Phase
5,5KW.( 5500W) 50/60 HZ

Bevel Length
max 59 mm

Bevel Angle
0° – 60°

Plate Thickness
8 – 60 mm (*) 8 – 100 mm

Feeding Speed
0 -1.4 mt/min

PORTABLE CHAMFER MILLING MACHINE
K-HFM/KaKi 2014-1-8-E

45°, 30°, 60° chamfers

The most economic way to mill 45°, 30°, 60° chamfers. The chamfer milling machine is used whenever predefined chamfers must be machined and is employed for the preparation of weld seams. This handy and powerful machine can also be utilised to produce visible edges. Furthermore, the machine can also be used to deburr sharp corners safely. Equipped with a radial mechanical stop, which is used as guide roller, the tool can also be used to machine inside contours and pipes.

Application range
· Sheet metal, pipes, flanges, inside contours, bores, etc.
· Steel, aluminium, stainless steel, castings, non-ferrous, metals, and plastics

The clamshell pipe cold cutter is ideal for all types of pipe cold cutting, beveling and end preparation. The split frame design allows the machine to split in half at the frame and mount around the OD of the in-line pipe or fittings for strong, stable clamping. The equipment performs precision in-line cut or simultaneous cut/bevel, counterbore operations, as well as weld end preparation on open ended pipe, Ranging from 3/4” to 56 inches O.D.(DN20-1400), on most wall thicknesses and material.

- Recycling capacity of 4, 10, 20 and 30 m³/h
- Dosing buffer and a special extension allow for fast discharge into the machine
- Large capacity wash drum (0.5-3.5 m³) guarantees best performance
- Compact design. No foundation mobile option available.
- Light aluminium cover supported by gas pressure springs
- Heated option available
- Hot-dip galvanised for longevity

A ComTec machine equipped with an external row of buckets. This compact solution lifts the waste from washing out concrete pumps or the batching plant into the ComTec without placing the machine below ground level. The external buckets are mounted on an extension of the main shaft of the machine.